I have the above radio and GPSMAP chartplotting receiver.
I have read through the manuals and have an idea of how they work individually but have not grasp the whole working together thing....
I registered and recieved my MMSI# but got to looking and realized the two units are not connected together.
The manual shows a wire diagram for the radio and one for the GPS plotter but they are not exactly the same... Does anyone have knowledge of how to wire these together and how they work together?
Or does anyone have a recommendation that won't cost me $95/hr shop time... I can wire it up if I just understood it better...
WinMag,
It sounds as though we have the same or a similar setup. I do have the Uniden Solara but my GPS Chartplotter is a Color Garmin. I'm away from home so I can't walk through the wiring with you right now but I can tell you that it was VERY easy. As a matter of fact I think there was only 1 wire to have your radio MMSI complete. I hope this helps, if not I'll be home next week.
WinMag,
Not sure about testing. Obviously if you have a friend with MMSI you could test it. Remember the radio is line of sight so unless you are on the water when you test it shouldn't be a problem. If you can wait til next spring I'll be up there with my boat and I can hel you with your test ;-)
One push of the little red guarded switch should test the system with someone else in range. Best of luck!
The little red button is for distress only, and the Coast Gaurd may respond. Wait for a friend that has MMSI. You can enter his number on into your radio and GPS. Then, using your radio instructions, you can "ping" him. When his radio replies, it will put a sailboat symbol on your gps screen showing you right where he is. It's a cool tool.