Announcement

Collapse
No announcement yet.

Fly rod storage suggestions for a drift boat

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • bowdy15
    replied
    Check out clakcas website, we have one, only two rod holders but it works really well, they are out of the way and you can even stand over the slots they slide into without stepping on any eyelets or the rod.

    Originally posted by G_Smolt View Post
    Strap about 7' of 2" pvc to the inside of each gunwale, then slide the rods inside.

    Not sure who started it (maybe clackacraft?), but a lot of newer driftboats have this option.

    Leave a comment:


  • LItoAK
    replied
    Originally posted by MTguy View Post
    You might try 9ft 2inches of 3 inch PVC. Angle. Them down as they go forward. Does a couple things. First your rod tips are enclosed. it also makes it easier to get the rods out. I lines mine with thin carpet. Couldn't stand listening to them scrape down when I put them in. I attached them with a U bolt about 3 ft from the top. Then cut the PVC on the top end above the U bolt in half level with the top of the gunnel. Makes it way easier to get the. Rods in and out and they are still protected. Got one on each side. Like bolsters.
    I'm following you up until you start cutting the PVC by the u bolts.

    Leave a comment:


  • MTguy
    replied
    You might try 9ft 2inches of 3 inch PVC. Angle. Them down as they go forward. Does a couple things. First your rod tips are enclosed. it also makes it easier to get the rods out. I lines mine with thin carpet. Couldn't stand listening to them scrape down when I put them in. I attached them with a U bolt about 3 ft from the top. Then cut the PVC on the top end above the U bolt in half level with the top of the gunnel. Makes it way easier to get the. Rods in and out and they are still protected. Got one on each side. Like bolsters.

    Leave a comment:


  • LItoAK
    replied
    Originally posted by G_Smolt View Post
    Strap about 7' of 2" pvc to the inside of each gunwale, then slide the rods inside.

    Not sure who started it (maybe clackacraft?), but a lot of newer driftboats have this option.
    That's a good idea I have seen people do that on top of trucks and cut out a notch in the back to seat the reel.

    Leave a comment:


  • G_Smolt
    replied
    Strap about 7' of 2" pvc to the inside of each gunwale, then slide the rods inside.

    Not sure who started it (maybe clackacraft?), but a lot of newer driftboats have this option.

    Leave a comment:


  • LItoAK
    started a topic Fly rod storage suggestions for a drift boat

    Fly rod storage suggestions for a drift boat

    I am looking for a way to organize the multitude of fly rods I always end up bringing out on the water. They always seem to end up in the back of the boat in a tangled mess. Definitely don't want to drill into the hull, got any suggestions?

Footer Adsense

Collapse
Working...
X