Announcement

Collapse
No announcement yet.

Outboard Jet maintenance

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Outboard Jet maintenance

    Just wondering what you all do for maintenance? Today i sharpened the impeller and shimmed it also. I am curious to see if i get a power increase. I also do the standard grease in the jet to. Thanks for the help.

    H2O

  • #2
    That's about all that can be done. I bend the fins straight so it doesn't stuck as many rocks also. I try to maintain it at the end of each season, that way I'm ready to pull out the boat and go when the water opens up.

    Comment


    • #3
      That's what I usually do.

      This spring, I will install a brand new impellor, wear ring, and grates/fins. They were so far gone that I've been suffering power on the river.

      Comment


      • #4
        What I do.

        Here is what I do. I pull the whole jet housing and inspect/replace, as needed, the water pump impeller and housing. The rivers we run are very silty and the erosion to the impeller housing is shocking. I then inspect the main impeller and liner. I always have a spare liner, so if it is bad I will replace it. My stainless impeller could probably use a tune up with a file. I then reinstall everthing, shimming as needed. At this same time I inspect the cables, rod ends, etc. I will then go through my spare parts. I like to carry a spare shaft key, shim stack, nut and lock washer along with an intake foot, liner and stud kit. Then on to the powerhead, steering and the rest of the boat.
        My Facebook My YouTube

        Comment

        Footer Adsense

        Collapse
        Working...
        X